Share:


On the definition of height reference surfaces over an arbitrary selected area by means of DFHRS approach

    Perparim Ameti Affiliation
    ; Reiner Jager Affiliation

Abstract

The aim of this study is to analyze the best fitting geoid model for an arbitrary selected area of investigation. The Digital Finite Element Height Reference Surface (DFHRS) method, developed by Hochschule Karlsruhe has been chosen to define the height reference surface for the territory of Kosovo, which should be defined as national vertical datum. This approach allows the conversion of ellipsoidal heights determined by GPS into the standard heights, which refer to the height reference surface (HRS) of an orthometric, or normal surface system. The DFHRS is defined as continues HRS in arbitrary large areas by bivariate polynomials over an irregular grid (Jager, Schneid 2001). The DFHRS approach uses wide range of the input data (Geometric and Physical) and in our case there were 30 GPS/leveling height data as well as physical derivatives from different global geopotential models. The proposed approach has been successfully applied and results are compared to actual normal heights and in selected profiles of digital elevation reference surface calculated from the national control network. Special attention has been given to the choice of the geopotential model and the selection of the pass points in source and target surface.

Keyword : GPS, Geoid Undulation, geopotential models, leveling

How to Cite
Ameti, P., & Jager, R. (2016). On the definition of height reference surfaces over an arbitrary selected area by means of DFHRS approach. Geodesy and Cartography, 42(4), 115-121. https://doi.org/10.3846/20296991.2016.1268431
Published in Issue
Dec 20, 2016
Abstract Views
551
PDF Downloads
538
Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.